Dealing with Zebra USB Connector problems? It has been known for sometime in the industry that the USB board Zebra Technologies uses has had bad solder connections. I have replaced many boards over the past two years. I finally decided to do something about it. Pictured below is a cable stay that I have found that greatly reduces the strain the cable has on the USB connector. I provide these free of charge to my customers. If you have a Zebra printer using the USB port and do not want it to break, Contact US and I will be glad to send you a cable stay for each printer you have at no charge, yes free! This .25 cent plastic piece is a whole lot less expensive than a $450.00 USB board plus installation.